Reconstitution is the process of turning a lyophilised (freeze-dried) peptide into a liquid solution. Doing it correctly protects the peptide's integrity and ensures accurate, consistent concentrations.

This guide walks through the process step by step.

Disclaimer: This guide is provided for research and laboratory handling purposes only. It is not medical advice and does not cover administration or dosing for human or animal use.

What you will need

  • Lyophilised peptide vial
  • Bacteriostatic water (BAC water)
  • Alcohol swabs
  • Sterile graduated syringes
  • A calculator or reconstitution calculator

Why Bacteriostatic water?

Bacteriostatic water is sterile, non-pyrogenic water containing 0.9% benzyl alcohol. The benzyl alcohol acts as a preservative, inhibiting bacterial growth so the vial can be accessed multiple times over a period of weeks.

Sterile water does not contain this preservative and is intended for single use only, with any remainder discarded after first use.

Step 1: Calculate Your Concentration

Before drawing any liquid, decide how much bacteriostatic water to add based on:

The total amount of peptide in the vial (e.g. 5mg or 10mg)
The concentration you require

Example: adding 2ml of bacteriostatic water to a 10mg vial gives a concentration of 5mg/ml.

More water = lower concentration per ml
Less water = higher concentration per ml

Choose a volume that gives a concentration you can measure accurately using the graduations on your syringe.

Step 2: Prepare Your Workspace

Wash your hands thoroughly.
Wipe down your work surface with an alcohol swab.
If either the peptide vial or the water has been refrigerated, allow both to reach room temperature. This reduces stress on the peptide structure during mixing.

Step 3: Sanitise the Vials

Remove the protective caps and wipe the rubber stoppers of both the peptide vial and the bacteriostatic water vial with a fresh alcohol swab.
Allow the alcohol to air-dry for a few seconds before proceeding.

Step 4: Draw the Water

Draw air into the syringe equal to the volume of water you plan to withdraw.
Insert the needle into the water vial and inject the air. This equalises the pressure and makes withdrawal easier.
Invert the vial and draw out your calculated volume of bacteriostatic water.

Step 5: Add Water to the Peptide Vial

Insert the needle through the peptide vial's rubber stopper at an angle.
Aim the needle so the water runs slowly down the inside wall of the vial, not directly onto the lyophilised powder.
Adding the water slowly and gently prevents excess foaming and minimises disruption to the peptide's structure.

Step 6: Allow It to Dissolve

Do not shake the vial. Shaking can denature (damage) the peptide by disrupting its structure.
Instead, gently swirl the vial or leave it to stand undisturbed. Most peptides dissolve within a few minutes.
If it is slow to dissolve, gently roll the vial between your palms.

Step 7: Inspect the Solution

The reconstituted solution should be clear and free from particles or cloudiness, unless the specific peptide is known to reconstitute with slight opacity.

Common Mistakes to Avoid

  • Shaking the vial instead of swirling it gently
  • Adding water directly onto the powder with force
  • Using expired or non-sterile water
  • Not swabbing the stoppers before each use
  • Estimating the concentration instead of calculating it precisely
  • Reusing needles across multiple draws, which increases the risk of contamination

Storage Guidelines

Temperature

Refrigerate at 2-8 degrees centigrade

Light exposure

Store in original box or wrap in foil – Many peptides are light sensitive

Typical stability window

Use within 28 days of reconstitution

Freezing

Not recommended after reconstitution as freeze-thaw cycles can degrade peptides